I had a 2.8, later got a 3.5, put the 2.8 back in its box.
Friend saw my 3.5, wanted one, told him I'd give him my 2.8 to play with.
Connected the 2.8 on the same cable that was working with the 3.5 to set it back up and make him a custom screen to save the guy time learning the GUI,
and when I connected it, my PC did not pick a new device. Tried it on another PC that never had the device or the drivers, window does not pick
up any new devices there either. Connected the 3.5 on the new PC, got it working in under a minute, 2.8 still does not get detected.
Current behavior:
1) When the 2.8 is connected on USB, nothing at all appears on the screen. The 3.5 instantly gives you a "welcome menu" saying "you need GOverlay, so go get it"
while the 2.8 screen is just BLANK all the entire time time, and I seem to remember that it ALSO used to show a splash message on powerup, but not doing it now.
2) When I connect the cable, what I assume is a small Blue LED inside the unit is blinking (I can see it near the usb plug), and it has a pattern, it's blink-blink-pause, blink-blink-pause.
Is the "double blink" some sort of internal error code? Anyone know what the code is? Is it "ha ha, I'm broken screw you buddy" because that's my current guess.
Thanks for any help.
Marco.