Re: HWiNFO Plugin (BETA)
Posted: Sun Feb 28, 2021 7:52 amThanks!
Page 21 of 36
Posted: Sun Feb 28, 2021 7:52 amRe: HWiNFO Plugin (BETA)
Posted: Sun Feb 28, 2021 1:45 pmthx
Re: HWiNFO Plugin (BETA)
Posted: Mon Mar 01, 2021 11:01 amthanks
Re: HWiNFO Plugin (BETA)
Posted: Sun Mar 07, 2021 12:38 pm
Re: HWiNFO Plugin (BETA)
Posted: Sun Mar 07, 2021 9:48 pmthx
Re: HWiNFO Plugin (BETA)
Posted: Tue Mar 09, 2021 1:42 pmThanks
Re: HWiNFO Plugin (BETA)
Posted: Tue Mar 09, 2021 3:28 pmDo not install the new HWInfo 7.00. Goverlay does not work fully with HWInfo 7.00.
In the new free license from HWInfo, there is only 12 hours of shared memory support. After this period, this setting must be activated again manually in the HW info settings.
In the new free license from HWInfo, there is only 12 hours of shared memory support. After this period, this setting must be activated again manually in the HW info settings.
Re: HWiNFO Plugin (BETA)
Posted: Tue Mar 09, 2021 4:56 pmGOverlay + HWiNFO 6.X
You can still use HWiNFO 6.X with GOverlay as usual.
GOverlay + HWiNFO 7.X FREE LICENSE
If you intend to use HWiNFO 7, it works with GOverlay but depends on your HWiNFO license.
If you use free license, you have to start HWiNFO in full mode, go to settings and enable shared memory support as the next image shows
http://prntscr.com/10ha3s3
After this, you still need to open the sensors tab, otherwise it will not send sensors info.
After you do this two steps, GOverlay will be able to read HWiNFO data from 12 hours straight, after that, you need to re-enable HWiNFO shared memory support
GOverlay + HWiNFO 7.X PRO LICENSE
You can still use HWiNFO 7.X with GOverlay as you used to use it with 6.X.
You can still use HWiNFO 6.X with GOverlay as usual.
GOverlay + HWiNFO 7.X FREE LICENSE
If you intend to use HWiNFO 7, it works with GOverlay but depends on your HWiNFO license.
If you use free license, you have to start HWiNFO in full mode, go to settings and enable shared memory support as the next image shows
http://prntscr.com/10ha3s3
After this, you still need to open the sensors tab, otherwise it will not send sensors info.
After you do this two steps, GOverlay will be able to read HWiNFO data from 12 hours straight, after that, you need to re-enable HWiNFO shared memory support
GOverlay + HWiNFO 7.X PRO LICENSE
You can still use HWiNFO 7.X with GOverlay as you used to use it with 6.X.
Re: HWiNFO Plugin (BETA)
Posted: Wed Mar 10, 2021 2:43 pmstill runing?
Re: HWiNFO Plugin (BETA)
Posted: Wed Mar 10, 2021 4:31 pmbin ich mal gespannt