Powersave Mode

Anything about GOverlay and the devices supported

Powersave Mode

Postby gerlin » Thu Jan 08, 2015 4:44 am

I am using GOverlay with the LCDSysInfo display.

When I have it configured to only read from an ini file (no other sensors being used), and the ini file has not been updated in a while, the display goes into power saving mode. When it comes out it does not display everything properly.

I believe I have worked around this by adding a hidden time object, though I wanted to find out if there is a way to disable the power save mode.

Thanks.

gerlin
 
Posts: 5
Joined: Thu Jan 08, 2015 3:22 am

Re: Powersave Mode

Postby TheLaGmAn » Wed Jan 14, 2015 4:17 pm

The power saving mode is builtin in the firmware and there is no way to disable it, i recommend adding a date/time sensor and make it hidden as you say, that will prevent the display from going into power saving mode.
User avatar
TheLaGmAn
Site Admin
 
Posts: 967
Joined: Wed Feb 26, 2014 8:32 pm


Return to About GOverlay



Who is online

Users browsing this forum: No registered users and 5 guests

cron