I just got the 3.5 display, but it's not working (stuck on run goverlay for config), but my 2.8 is working nicely
here it goes :
If I plug the 2 of them at the same time: on the STATUS page of goverlay BOTH are GREEN, enable and detected but only the 2.8 is working and the 3.5 stuck at run goverlay for config.
If I plug the 3.5 alone: STATUS page is YELLOW for the 2.8 AND the 3.5 and BOTH are enable and NOT detected.
if I plug the 2.8 alone, BOTH ARE GREEN, 2.8 and 3.5 enable AND detected!!!
GOverlay version 1.6.3
yes, I put a profile on the 3.5 (tested all of them)
And the log is killing me with this:
17/oct./2017 19:55:40:LCDSysInfo2 - Error opening device
17/oct./2017 19:55:40:LCDSysInfo2 - Init
17/oct./2017 19:55:40:ProcessWatch - Resetting Watcher "\Process(*)\% Processor Time" -si 1
17/oct./2017 19:55:39:LCDSysInfo2 - Error opening device
17/oct./2017 19:55:39:LCDSysInfo2 - Init
17/oct./2017 19:55:38:LCDSysInfo2 - Error opening device
Can someone help me??