Hello, how did you manage that your display is recognized by the system again and that you can install the new firmware?
With best regards
Andreas Dietz
TheLaGmAn wrote:how far into goverlay does this happen?
Can you enter in firmware upgrade mode?
You could try to update the firmware, according to the manufacturer low usb voltage could of messed with it.
I can only provide an upgrade path within GOverlay, only if you can successfuly start the upgrade from GOverlay itself.
If you cant do it, please contact coldtearselectronics@gmail.com requesting an alternative upgrade method.
To do it from GOverlay:
disconnect the unit.
open goverlay,
select in the lcdsysinfo 3.5'' tab an empty profile (or create one) so it doesnt request to draw anything to the display. hit apply.
go to update firmware from file in the tools section, select the fw file. DO NOT CLICK OPEN connect lcdsysinfo click OPEN
see if the device is detected in firmware mode and continue with firmware upgrade
Users browsing this forum: No registered users and 4 guests