I just recieved de LCDSysInfo 3.5. I am using GOverlay 1.6.9 and using AIDA64 for the sensors. The five numbers at the bottom row are my case fan speeds.
But when I set my fan speeds around 500 RPM I see this:
The correct should be 545, 508, 497, 521 and 520. So basically the last digit are not cleared while it should be. Those digits will be cleared when I click on Save and Apply in Profiles section in the GOverlay software.
How can I solve this issue?
One workaround is to set the number of digints to 4 and use zero's to fill. But those zero's I find ugly.