Page 1 of 1

sent email to support no dice 3.5 inch display

PostPosted: Sun Oct 27, 2019 5:55 am
by Mage_Mors
hey guys I am having an issue where the goverlay screen has been working flawlessly for 5 months now and last night it went dark. When I turned on the pc the display seemed to lose horizontal sync until the driver kicked it and it started loading normally. When it got to 90% of "Getting sector data..." "Getting the file table 90%" on the initial load it stopped and generated the following error.

Image

Then it says device needs update so I click the device needs update button when going into goveraly and it just sits and loads nothing.

Is there a reset. I tried reloading the software but no dice.

Re: sent email to support no dice 3.5 inch display

PostPosted: Mon Nov 11, 2019 12:40 am
by TheLaGmAn
go to the 3.5'' tab, tools and click on "upload file table from file" and use the one attached, see if it fixes it.